Toyota RAV4 (XA40) 2013-2018 Service Manual: Air conditioning
- Air conditioning system (for automatic air conditioning system)
- Precaution
- Parts location (2005/11-2006/01)
- Parts location (2006/01- )
- System diagram
- System description
- How to proceed with troubleshooting (2005/11-2006/01)
- How to proceed with troubleshooting (2006/01- )
- Customize parameters
- Problem symptoms table (2005/11-2006/01)
- Problem symptoms table (2006/01- )
- Terminals of ecu (2005/11-2006/01)
- Terminals of ecu (2006/01- )
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Data list / active test (2005/11-2006/01)
- Data list / active test (2006/01- )
- Diagnostic trouble code chart (2005/11-2006/01)
- Diagnostic trouble code chart (2006/01- )
- Air conditioning system (for manual air conditioning system)
- Precaution
- Parts location (2005/11-2006/01)
- Parts location (2006/01- )
- System diagram
- System description
- How to proceed with troubleshooting (2005/11-2006/01)
- How to proceed with troubleshooting (2006/01- )
- Problem symptoms table (2005/11-2006/01)
- Problem symptoms table (2006/01- )
- Terminals of ecu (2005/11-2006/01)
- Terminals of ecu (2006/01- )
- Diagnosis system
- Dtc check / clear
- Data list / active test (2005/11-2006/01)
- Data list / active test (2006/01- )
- Diagnostic trouble code chart (2005/11-2006/01)
- Diagnostic trouble code chart (2006/01- )
- Refrigerant
- Refrigerant line
- Air conditioning unit
- Blower unit
- Blower motor
- Blower resistor
- Air inlet control servo motor
- Air mix control servo motor (for automatic air conditioning system)
- Compressor and pulley (for 2az-fe)
- Compressor and pulley (for 2gr-fe)
- Condenser
- Room temperature sensor (for automatic ai conditioning system)
- Evaporator temperatur sensor
- Solar sensor (for automatic air conditioning system)
- Heater relay
- Air conditioning control assembly (for automatic air conditioning system)
- Air conditioning control assembly (for manual air conditioning system)
Tire pressure warning ecu
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Other materials:
Installation
Install mass air flow meter
Install the mass air flow meter with the 2 screws.
Notice:
Make sure that the o-ring is not cracked or
jammed when installing it.
Connect the mass air flow meter connector.
Connect cable to battery negative terminal
...
Active test
Hint:
Performing an active test enables components
including the relays, vsv (vacuum switching valve) and
actuators, to be operated without removing any parts.
The active test can be performed with the intelligent
tester. Performing the active test as the first step of
troubleshooting is one ...
Air-fuel ratio (a/f) and heated oxygen (ho2) sensor
heater monitors (front a/f and rear ho2 sensor type)
Preconditions
The monitor will not run unless:
The mil is off.
Drive pattern
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Turn the tester on.
Clear dtcs (if set) (see page es-35).
Start the engine.
Allow the engine to idle for 10 minute ...
