Toyota RAV4 (XA40) 2013-2018 Service Manual: Blower motor
On-vehicle inspection
- Inspect blower motor (for automatic air conditioning system)
- Disconnect the blower motor connector.
- Connect the positive (+) lead from the battery to
terminal 1 and negative (-) lead to terminal 2, and
then check that the motor operates smoothly.
If the operation is not as specified, replace the blower motor.
- Inspect blower motor (for manual air conditioning system)
- Disconnect the blower motor connector.
- Connect the positive (+) lead from the battery to
terminal 2 and negative (-) lead to terminal 1, and
then check that the motor operates smoothly.
If the operation is not as specified, replace the blower motor.
Blower unit
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent ai ...
Blower resistor
On-vehicle inspection
Inspect blower motor control
Measure the resistance of the blower resistor.
Standard resistance
If the resistance is not as specified, replace the
blower moto ...
Other materials:
Terminals of ecu (2005/11-2006/01)
Check air conditioning amplifier
Measure the voltage and resistance of the
connectors.
Hint:
Check from the rear of the connector while it is
connected to the air conditioning amplifier.
Using an oscilloscope, check waveform 1.
Compressor and pulley operation signa ...
Solar sensor (for automatic air conditioning system)
Components
Removal
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pretensioner activation.
Remove solar sensor
Using a screwdriver, p ...
Adjusting the settings manually
To adjust the fan speed, press
on
to increase the fan
speed and to
decrease the fan speed.
Press to turn the fan off.
To adjust the temperature setting, turn
clockwise to
increases the temperature and turn
counterclockwise to
...
