Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Drive shaft

Installation
Hint: Use the same procedures for the rh side and lh side. The procedures listed below are for the lh side. Install rear stabilizer bush Install the 2 bushes. Hint: Instal ...

Drive shaft system
...

Other materials:

A/f sensor circuit slow response (bank 1 sensor 1)
Hint: Sensor 1 refers to the sensor mounted in front of the three-way catalytic converter (twc) and located near the engine assembly. Description Refer to dtc p2195 (see page es-292). Monitor description After the engine is warmed up, the ecm performs air-fuel ratio feedback contro ...

Pressure control solenoid "b" electrical (shift solenoid valve sl2)
Description Shifting from 1st to o/d is performed in combination with the on and off operation of the shift solenoid valves sl1 and sl2, which are controlled by the ecm. If an open or short circuit occurs in any of the shift solenoid valves, the ecm controls the remaining normal shift sol ...

Short in front driver side pretensioner squib circuit
Description The driver side front pretensioner squib circuit consists of the center airbag sensor and the front seat outer belt lh. This circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in the front prete ...

В© 2011-2026 Copyright www.trav4.net