Operating HomeLink
Cleaning and protecting the vehicle exteriorInstallation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
When installing the moulding, heat the vehicle body and
moulding using a heat light.
Standard heating temperature
Notice:
Do not heat the vehicle body and moulding
excessively ...
Theft deterrent system
Engine immobilizer system
The vehicle’s keys have built-in transponder chips that prevent
the engine from starting if a key has not been previously registered
in the vehicle’s on-board computer.
Never leave the keys inside the vehicle when you leave the vehicle.
This system is designed to ...
Transmitter id not registered in main mode
Description
Inspection procedure
Notice:
It is necessary to register an id code after replacing the tire pressure
warning valve and
transmitter and/or the tire pressure monitor ecu (see page tw-9).
Hint:
Set the tire pressure to the specified value.
Standard pressure:
220 kpa (2.2 ...