Toyota RAV4 (XA40) 2013-2018 Service Manual: Sliding roof
- Sliding roof system
- System description
- How to proceed with troubleshooting
- Initialization
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Data list / active test
- On-vehicle inspection
- Sliding roof housing
- Components (2005/11-2006/01)
- Components (2006/01- )
- Removal (2005/11-2006/01)
- Removal (2006/01- )
- Disassembly
- Reassembly
- Installation (2005/11-2006/01)
- Installation (2006/01- )
- Sliding roof switch assembly
Child restraint seat tether anchor
Components
Removal
Remove child restraint seat tether anchor cover
Using a screwdriver, detach the 4 claws and remove
the cover.
Hint:
...
Sliding roof system
Parts location
System diagram
Communication table
...
Other materials:
Terminals of ecm
Check ecm
Disconnect the a9 and b30 connectors.
Measure the voltage and resistance of the wire
harness side connectors.
If the result is not as specified, there may be a
malfunction on the wire harness side. ...
Reassembly
Install wiring harness clamp bracket
Install the bracket with the bolt.
Install elbow tube
Install straight pin
Using a plastic hammer, install the 4 straight pins to
the rear differential carrier.
Thoroughly clean oil and water from the surface of
the rear different ...
Air-fuel ratio (a/f) and heated oxygen (ho2) sensor
heater monitors (front a/f and rear ho2 sensor type)
Preconditions
The monitor will not run unless:
The mil is off.
Drive pattern
Connect the intelligent tester to the dlc3.
Turn the ignition switch on.
Turn the tester on.
Clear dtcs (if set) (see page es-35).
Start the engine.
Allow the engine to idle for 10 minute ...
