Toyota RAV4 (XA40) 2013-2018 Service Manual: Lighting
- Lighting system
- Parts location
- System description
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Problem symptoms table (2005/11-2006/01)
- Problem symptoms table (2006/01- )
- Terminals of ecu
- Data list / active test
- Headlight assembly
- Fog light assembly
- Rear combination light assembly
- License plate light assembly
- High mounted stop light assembly
- Map light assembly
- Room light assembly
- Luggage room light
- Ignition key cylinder light
- Vanity light
- Front console illumination
- Footwell light
- Headlight dimmer switch
- Hazard warning switch
- Front door courtesy switch
- Rear door courtesy switch
- Headlight relay
- Daytime running light relay
- Fog light relay
- Brk relay
Air conditioning control assembly (for manual air conditioning system)
Components
Removal
Disconnect cable from negative battery
terminal
Notice:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent air ...
Lighting system
...
Other materials:
Compressor solenoid circuit (2005/11-2006/01)
Description
In this circuit, the compressor receives a refrigerant compression demand
signal from the air conditioning
amplifier. Based on this signal, the compressor changes the degree of
refrigerant compression.
Wiring diagram
Inspection procedure
Read value of intelligent ...
On-vehicle inspection
Check throttle body
Check the throttle control motor operating sounds.
Turn the ignition switch on.
When pressing the accelerator pedal, check
the operating sound of the running motor. Make
sure that no friction noises emit from the motor.
If friction noise exists, replace t ...
Skid control sensor (for 2wd)
Components
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery termin ...
