Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Service Manual: Headlight relay

On-vehicle inspection

  1. Remove headlight relay

Toyota RAV4. Remove headlight relay


  1. Remove the headlight relay from the engine room no. 2 Relay block.
  2. Measure the resistance of the relay.

Standard resistance


If result is not as specified, replace the relay.

Rear door courtesy switch
Components Removal Hint: Use the same procedures for the rh and lh sides. The procedures listed below are for the lh side. Disconnect cable from negative battery terminal Cautio ...

Daytime running light relay
On-vehicle inspection Inspect day time running light relay Remove the no. 2 Relay, no. 3 Relay and no. 4 Relay from the engine room no. 2 Relay block. Measure the resistance of the r ...

Other materials:

Compressor circuit
Description When the a/c switch is turned on, the magnetic clutch on signal is sent from the air conditioning amplifier. Then the mg clt relay turns on to operate the magnetic clutch. Wiring diagram Inspection procedure Inspection procedure Perform active test by intelligent tester (a ...

Floor shift assembly
Components Removal Disconnect cable from negative battery terminal Caution: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation. Remove shift lever knob sub-assembly Remove re ...

Functions included in LTA system
â–  Lane departure alert function When the system determines that the vehicle might depart from its lane or course*, a warning is displayed on the multi-information display, and a warning buzzer will sound to alert the driver. When the warning buzzer sounds, check the area around your vehicle and c ...

© 2011-2026 Copyright www.trav4.net