Registering a bluetooth® device in the system allows the system to function. The following functions can be used for registered devices:
Functions and operation procedures
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Registering a bluetooth® device
Select “bt pairing” using the “tune•scroll” knob.
Perform the procedure for registering a bluetooth® device from step 3.
After disconnecting, perform the procedure for registering a bluetooth® device from step 2
Listing the registered cellular phones
Select “list phone” using the “tune•scroll” knob. The list of registered cellular phones will be displayed.
Connecting the registered cellular phone to the audio system
Deleting a registered cellular phone
Disconnecting the registered cellular phone from the audio system
Listing the registered portable players
Select “list audio” using the “tune•scroll” knob. The list of registered portable players will be displayed.
Connecting the registered portable player to the audio system
Deleting the registered portable player
Disconnecting the registered portable player from the audio system
Selecting the connection method
Changing the passkey
Input the number 1 digit at a time.
If the passkey to be registered has 8 digits, pressing
(enter) is
not
necessary.
Setting automatic connection of the device on or off
If “bt power” is set to on, the registered device will be connected automatically when the engine switch is turned to the “acc” position (vehicles without a smart key system) or accessory mode (vehicles with a smart key system).
Displaying the device status
Select “bluetooth* info” using the “tune•scroll” knob.
Select “device name” using the “tune•scroll” knob.
Select “device address” using the “tune•scroll” knob.
*: Bluetooth is a registered trademark of bluetooth sig, inc.
Setting the automatic connection confirmation display to on or off
If the “display setting” is set to on, the portable player connection status will be displayed when the engine switch is turned to the “acc” or “on” position (vehicles without a smart key system) or accessory or ignition on mode (vehicles with a smart key system).
Initialization
Select “initialize” using the “tune•scroll” knob.
Select “sound setting” using the “tune•scroll” knob and press
(yes).
For details about sound settings
Select “car device info” using the “tune•scroll” knob and press
(yes).
Automatic connection of a portable device, automatic connection confirmation display and the passkey will be initialized.
The number of bluetooth® device that can be registered
Up to 5 bluetooth® device can be registered in the system.
Bluetooth® audio/phone system functions
Certain functions may not be available during driving.
Intake air temperature circuit malfunction
Description
The intake air temperature (iat) sensor, mounted on the mass air flow (maf)
meter, monitors the iat.
The iat sensor has a built-in thermistor with a resistance that varies according
to the temperature of the
intake air. When the iat is low, the resistance of the thermist ...
System description
Description
The eps (electronic power steering) system generates
torque through the operation of the motor and the
reduction gear installed on the column shaft in order to
assist steering effort.
The power steering ecu determines directions and the
amount of assisting power in accordanc ...
Transmission control cable assembly
Replacement
Remove rear console box sub-assembly
Remove the console box (see page ip-20).
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and seat belt pre ...