Once a bluetooth® phone is registered, you can make a call using the following procedure:
Dialing
To delete the input phone number, select
.
For the first digit, you can enter
by selecting
for a while.
switch on the
.Dialing from the contacts list
You can dial a number from the contact data imported from your cellular phone. The system has one contact for each registered phone. Up to 2500 contacts may be stored in each contact.
switch on the steering
.
When the contact is empty
You can transfer the phone numbers in a bluetooth® phone to the system.
Operation methods differ between pbap (phone book access profile) compatible and pbap incompatible bluetooth® phones. If the cellular phone does not support either pbap or opp (object push profile) service, you cannot transfer contacts.
For pbap compatible bluetooth® phones
When “automatic contact/history transfer� is set to off

For pbap incompatible but opp compatible bluetooth® phones

When “transfer� is selected
When “add� is selected
Calling using favorites list
You can make a call using numbers registered in the contact.
Dialing from call history
You can make a call using the call history, which has the 3 functions below.
Calls which you missed
Calls which you received
Calls which you made
or the desired entry
When
is selected
When the desired contact is selected
call history list
International calls
You may not be able to make international calls, depending on the mobile phone in use.
Using a bluetooth®
phone
Receiving a callEcu malfunction
Description
Inspection procedure
If the power steering ecu detects these dtcs, it will shut off the motor
relay circuit (built into the power
steering ecu) and stop power assist. However, power assist continues if dtc
c1533 is output.
Reconfirm dtc
Check for dtc.
Ok:
dtc i ...
Data list / active test
Read data list
Hint:
Using the intelligent tester's data list allows switch,
sensor, actuator, and other item values to be read
without removing any parts. Reading the data list
early in troubleshooting is one way to save time.
Notice:
In the table below, the values listed under "no ...
Transmission range sensor circuit malfunction (prndl input)
Description
The park/neutral position (pnp) switch detects the shift lever position and
sends signals to the ecm.
Monitor description
These dtcs indicate a problem with the park/neutral position switch and the
wire harness in the park/
neutral position switch circuit.
The park/neu ...