Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: High beam automatic turning on or off conditions

When all of the following conditions are fulfilled, high beam will be automatically turned on:

If any of the following conditions are fulfilled, high beam will be automatically turned off:

Activating the automatic high beam system
Push the lever away from you with the headlight switch in position. The automatic high beam indicator will come on when the headlights are turned on automatically to indicate that the system i ...

Turning the high beam on/off manually
Switching to low beam Pull the lever to original position. Switching to high beam Turn the light switch to position. The automatic high beam indicator will turn off and the high beam indic ...

Other materials:

Folding the mirrors
Push the mirror back in the direction of the vehicle’s rear. Mirror angle can be adjusted when Vehicles without a smart key system The engine switch is in the “acc� or “on� position. Vehicles with a smart key system The engine switch is in accessory or ignition on mode. ...

Propeller shaft assembly
Components Removal Remove propeller shaft with center bearing shaft assembly Remove the 2 bolts and 2 adjusting washers, and disconnect the propeller with center bearing shaft. Notice: During the removal, do not exert excessive force on the universal joint. When r ...

Installation
Replace roof carrier seal Remove the seals. Install new seals as shown in the illustration. Install roof rack leg front lh Install the leg cushion front. Install the roof rack leg front with the 2 screws. Torque: 2.8 To 5.0 N*m (29 to 51 kgf*cm, 25 to 44 in.*Lbf) ...

© 2011-2026 Copyright www.trav4.net