Toyota RAV4 (XA40) 2013-2018 Service Manual: Components (2005/11-2006/01)
Sliding roof ecu power source circuit
Description
If the sliding function and tilt function do not operate, there may be a malfunction in the sliding roof ecu power source circuit.
Wiring diagram
Inspection procedure
- Perform active test by intelligent tester (sliding roof operation)
- Select the active test, use the intelligent tester to generate a control command, and then check that the sliding roof operates normally.
Sliding roof ecu
Ok: sliding roof operates normally.
- Inspect fuse (s/roof, ecu-ig1)
- Remove the s/roof and ecu-ig1 fuses from the instrument panel junction block.
- Measure the resistance of the fuses.
Standard resistance:
below 1 
- Check wire harness (sliding roof drive gear - body ground)
- Disconnect the p6 drive gear connector.
- Measure the voltage and resistance of the wire harness side connector.
Standard voltage 
Standard resistance 
Replace sliding roof drive gear sub-assembly
Other materials:
Side airbag sensor
Components
On-vehicle inspection
Check side airbag sensor (vehicle not
involved in collision)
Perform a diagnostic system check (see page rs-
49).
Check side airbag sensor (vehicle involved
in collision and airbag has not deployed)
Perform a diagnostic system check ( ...
Removal
Remove package tray trim pocket subassembly
(w/o rear no. 2 Seat)
Remove tonneau cover assembly (w/o rear
no. 2 Seat)
Remove rear floor no. 1 Board (w/o rear no.
2 Seat)
Remove deck board assembly (w/o rear no. 2
Seat)
Remove rear floor no. 3 Board (w/o rear no.
2 Seat)
Re ...
A/f sensor circuit slow response (bank 1 sensor 1)
Hint:
Sensor 1 refers to the sensor mounted in front of the three-way catalytic
converter (twc) and located
near the engine assembly.
Description
Refer to dtc p2195 (see page es-292).
Monitor description
After the engine is warmed up, the ecm performs air-fuel ratio feedback
contro ...
