Toyota RAV4 manuals

Toyota RAV4 (XA40) 2013-2018 Owners Manual: Correct use of the seat belts

Make sure that all occupants are wearing their seat belts before driving the vehicle.

Use a child restraint system appropriate for the child until the child becomes large enough to properly wear the vehicle’s seat belt.

Correct driving posture
Adjust the angle of the seatback so that you are sitting straight up and so that you do not have to lean forward to steer. Adjust the seat so that you can depress the pedals fully and ...

Adjusting the mirrors
Make sure that you can see backward clearly by adjusting the inside and outside rear view mirrors properly. Caution Observe the following precautions. Failure to do so may result in death or ser ...

Other materials:

Rear axle hub and bearing
Components On-vehicle inspection Remove rear wheel Disconnect rear drive shaft assembly lh (for 4wd) Disconnect the drive shaft (see page ds-69). Remove rear disc brake cylinder assembly lh (see page br-55) Remove rear disc (see page br-57) Check bearing backlash a ...

Checking the coolant
The coolant level is satisfactory if it is between the "FULL" and "LOW" lines on the reservoir when the engine is cold. Reservoir cap "FULL" line "LOW" line If the level is on or below the "LOW" line, add coolant up to the "FULL" line. â– Coolant selection Only use "Toyota Super Long Life Cool ...

Transmitter id not registered in main mode
Description Inspection procedure Notice: It is necessary to register an id code after replacing the tire pressure warning valve and transmitter and/or the tire pressure monitor ecu (see page tw-9). Hint: Set the tire pressure to the specified value. Standard pressure: 220 kpa (2.2 ...

© 2011-2026 Copyright www.trav4.net