Toyota RAV4 (XA40) 2013-2018 Service Manual: General maintenance (2005/11-2006/01)
- Inspect drive belt (see page em-6)
- Replace spark plugs (see page ig-7)
- Replace air cleaner filter
- Remove the air filter.
- Visually check that the air filter is not excessively damaged or oily.
- Replace the air filter with a new one, if necessary.
- Replace engine oil and oil filter (see page lu-1)
- Replace engine coolant (see page co-1)
- Inspect gasket in fuel tank cap (see page ec-25)
- Inspect fuel lines and connections, fuel tank vapor vent system hoses
- Visually check the fuel lines for cracks, leakage, loose connections, deformation.
- Inspect exhaust pipes and mountings
- Visually check the pipes, hangers and connections for severe corrosion, leaks or damage.
- Inspect valve clearance (see page em-8)
Engine
...
General maintenance (2006/01- )
Inspect drive belt (see page em-7)
Replace spark plugs (see page ig-7)
Replace air cleaner filter
Remove the air filter.
Visually check that the air filter is not excessively
damaged ...
Other materials:
Brake pedal load sensing switch
On-vehicle inspection
Inspect brake pedal load sensing switch
Hint:
Do not remove the brake pedal load sensing switch
from the brake pedal support.
When there is a malfunction in the brake pedal load
sensing switch, replace the brake pedal support.
Disconnect the brake pedal l ...
Installation
Hint:
Use the same procedures for the rh side and lh side.
The procedures listed below are for the lh side.
Install rear stabilizer bush
Install the 2 bushes.
Hint:
Install each bush to the outer side of the bush
stopper on each stabilizer bar.
Install each bush with ...
Communication
Description
The skid control ecu sends signals such as cruise control cancel demand
signals and brake operation
demand from ecm response signals to the ecm when the cruise control system is in
operation.
Inspection procedure
Hint:
This circuit uses can communication. Therefore, if t ...
