Toyota RAV4 (XA40) 2013-2018 Service Manual: Operation check
- Check electrical door lock operation
- Check the basic function.
- Check that all doors lock when the door control
switch (for manual operation) is turned to lock
and all doors unlock when turned to unlock.
- Check that all doors lock when the driver side
door lock key cylinder is turned to lock using
the key
- Check that only the driver side door unlocks
when the driver side door lock key cylinder is
turned to unlock and all doors unlock when
turned to unlock once again within 3 seconds
using the key (2-step unlocking function).
- Check the key lock-in prevention.
Notice:
In order to prevent the key from being actually
locked-in, the inspection should be made with
the driver side door window open.
- Have the key inserted into the ignition key
cylinder.
- With the driver side door open, check that all
doors unlock immediately after the door lock
knob for the driver side door is turned to lock.
- With the driver side door open, check that all
doors unlock immediately after the door control
switch (for manual operation) is turned to lock.
- With the driver side door open, turn the driver
side door lock knob to lock and hold it for 2
seconds or more, and then close the driver side
door. Then check that all doors unlock.
Hint:
Use the procedure to troubleshoot the power door lock
control system.
*: Use the intelligent tester.
Vehicle brought to workshop
Inspect battery voltage
Standard voltag ...
Customizing function with intelligent
tester (reference)
Hint:
The following item can be customized.
Notice:
When the customer requests a change in a
function, first make sure that the ...
Other materials:
Installation (2005/11-2006/01)
Install sliding roof weatherstrip
Install the sliding roof weatherstrip.
Position the joint of the weatherstrip at the rear
center.
Align the marks on the weatherstrip with the
middle marks at the corners of the plastic on
the edge of the sliding roof panel and install the ...
Vehicle lift and support locations
Notice about vehicle condition when
jacking up vehicle
The vehicle must be unloaded before jacking up /
lifting up the vehicle. Never jack up / lift up a heavily
loaded vehicle.
When removing heavy parts such as the engine and
transmission, the center of gravity of the vehicle
m ...
Installation
Install crankshaft position sensor
Notice:
Make sure that the o-ring is not cracked or jammed
when installing it.
Apply a light coat of engine oil to the o-ring of the
sensor.
Install the sensor with the bolt.
Torque: 9.0 N*m (90 kgf*cm, 80 in.*Lbf)
Install the wire ha ...