Toyota RAV4 (XA40) 2013-2018 Service Manual: Ignition system

2Az-fe ignition

Parts location

Other materials:

Catalyst monitor (active air-fuel ratio control type)
Preconditions The monitor will not run unless: The mil is off. Drive pattern Connect the intelligent tester to the dlc3. Turn the ignition switch on. Turn the tester on. Clear dtcs (if set) (see page es-35). Start the engine and warm it up. Drive the vehicle at be ...

Short in driver side squib circuit
Description The driver side squib circuit consists of the center airbag sensor, the spiral cable and the steering pad. The circuit instructs the srs to deploy when the deployment conditions are met. These dtcs are recorded when a malfunction is detected in the driver side squib circui ...

Disassembly
Remove no. 1 Side defroster nozzle duct Remove the 3 screws and duct. Remove no. 2 Side defroster nozzle duct Remove the 3 screws and duct. Remove no. 1 Heater to register duct Remove the screw and duct. Remove no. 2 Heater to register duct ...