Toyota RAV4 (XA40) 2013-2018 Service Manual: Airbag system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Problem symptoms table
- Terminals of ecu
- Diagnosis system
- Dtc check / clear
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
Precaution
Caution:
The vehicle is equipped with a supplemental restraint
system (srs), which consists of a steering pad, front
passenger airbag, curtain shield airbag, front seat side
airbag, seat bel ...
Other materials:
Removal
Remove package tray trim pocket subassembly
(w/o rear no. 2 Seat)
Remove tonneau cover assembly (w/o rear
no. 2 Seat)
Remove rear floor no. 1 Board (w/o rear no.
2 Seat)
Remove deck board assembly (w/o rear no. 2
Seat)
Remove rear floor no. 3 Board (w/o rear no.
2 Seat)
Re ...
Removal
Hint:
Use the same procedures for the lh side and rh side.
The procedures listed below are for the lh side.
Disconnect cable from negative battery
terminal
Caution:
Wait at least 90 seconds after disconnecting the
cable from the negative (-) battery terminal to
prevent airbag and ...
Skid control buzzer circuit
Description
The skid control buzzer sounds while the vsc is activated.
Wiring diagram
Inspection procedure
Notice:
When replacing the abs and traction actuator, perform the zero point
calibration (see page bc-
24).
Check can communication system
Check if the can communication d ...
